Adding Bracket to New Transom

[billfisher]

After raising the transom from 25 to 30 inches, I decided to do this??? I used Coosa 26 for the engine box, two layers of 3/4" with two layers of 1708 mat in and out of each layer. The float pods on each side are 1" corecell with the same glass and then filled with two part foam. I estimate the whole thing weighs about 100 to 110 pounds. I hope it workes out. Set back is now 25 inches from the original transom, but I am also adding a CMC 5.5 inch set back hydraulic jackplate for running in skinny water. Any thoughts or comments would be appricated.