Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > General Discussion > Performance
FAQ Community Calendar Today's Posts Search

Notices

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #9  
Old 07-06-2009, 06:17 PM
joshmon71 joshmon71 is offline
Senior Member
 
Join Date: Mar 2008
Location: Cape Cod, MA
Posts: 194
Default Re: Volvo Trim Tabs

Can someone with the Ql tabs on a 23 take a measurement from bottom of the outside strake (hull bottom) to top of QL tab? Alternatively I am in Chatham MA (boat in south harwich) and for a six pack of your choice would appreciate the 15 seconds to measure myself! I cannot fit the 12x12 bennets with a bracket-I would need to drop the bracket/engine and cut it, the actuator hits the bracket on the 90 degree piece of bracket that meets the hull, so no way can finagle a cut when on the boat that I can figure out. Plus the bennet mounting plate for tab hits the bottom of the scupper ( could cut the mount plate I suppose). If the QL tabs will fit it is a no brainer. Took the boat out this weekend in some 2-4 seas in the Bay and off Race Point, and would have liked the tabs . Just put a merc 4 blade revolution 17P prop on yesterday so will see how that does to help as well.

Thanks!

PS-The 300MM QL trim tabs=12 inches
__________________
---------
1977 Seacraft, Armstrong Bracket
275(chipped 250!) Verado
Merc Rev 4 17P
Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 10:49 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft