Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > General Discussion > Repairs/Mods.
FAQ Community Calendar Today's Posts Search

Notices

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #9  
Old 01-11-2012, 10:00 PM
Blue_Heron Blue_Heron is offline
Senior Member
 
Join Date: Jan 2006
Location: Gator Country
Posts: 1,416
Default

Mike,
You've got the opinions of two professionals, I'll add the opinion of an amateur that's done a little research and played with both resins.

Poly is "good enough", epoxy is better. Why? For an amateur, epoxy is easier to mix, easier to work with, and has little to no odor. A guy using poly resin in an attached garage may run the whole family out of the house with styrene fumes.

Epoxy also has better secondary bond strength, is water proof while poly is only water resistant, and has the best physical characteristics of any of the laminating resins. But it's the most expensive, too.

Either will work, epoxy will work better, last longer, and cost more. So, ya pays yer money and takes yer choice.
__________________
Blue Heron Boat Works
Reinventing the wheel, one spoke at a time.
Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 04:38 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft