stringer pieces in place.

[Bigshrimpin]

Got the front section of the floor leveled. I used the sheet of 3/4" MDO crezon
cut into 3" strips. A 4x8 sheet is just enough material to cover the stringer tops with 2 strips (which raises the floor 1.5" + 1/4" of epoxy puddy/glass). I was very impressed . . . the MDO had a only few small voids in the entire sheet.

I still have to level the back 7ft of the boat, round the sharp edges, and add 2 layers of 1808 over the tops of the stringers.

The make shift floor is a bunch of mdf scraps.

[pogden]

Whooh, that looks like a lot of work! But I can't wait to ge started [img]/images/graemlins/grin.gif[/img],yeah I am sick.

It looks like it is slowly coming together. You raised the original stringer framework all up to the same height using glass filled with foam and now you are raising it up with strips of MDO covered with glass.
[3/4" MDO + 3/4" MDO + 1/4" glass = 1 3/4" (stringers)
[3/4" sheet of MDO + (+)glass = (+)3/4" (for floor)
total height = (+)2 1/2"

[pogden]

Whooh, that looks like a lot of work! But I can't wait to ge started [img]/images/graemlins/grin.gif[/img],yeah I am sick.

It looks like it is slowly coming together. You raised the original stringer framework all up to the same height using glass filled with foam and now you are raising it up with strips of MDO covered with glass.
[3/4" MDO + 3/4" MDO + 1/4" glass = 1 3/4" (stringers)
[3/4" sheet of MDO + (+)glass = (+)3/4" (for floor)
total height = (+)2 1/2"

Is that right??