Bow rail, 20 ,deep 6 or repair

[TUGBOAT]

Run a 1" tape line around the top cap outside & Inside . Then NoN-Skid it. Slight contrasting paint.Cleans it up & will stop Ya from slipping off(What the Foot/Hand rail did before.

Just an idea. [img]/images/graemlins/cool.gif[/img]

[Capt Chuck]

Yo Tug

What kind of "VERMITS" y'al gots hanging around that SeaCraft that you need to squirt 'em with that yeller thing [img]/images/graemlins/confused.gif[/img]



Hope it's not one of dem "Cooters" you be servin up on a plate of gritz

[Finster]

Man! you guys get redder everyday. What the hell is the matter gritz? [img]/images/graemlins/confused.gif[/img] Ok fine grits. Is that better? [img]/images/graemlins/mad.gif[/img]

[Joe R]

LOOKING FOR GUNNEL MOUNT ROD HOLDER !!!!!!PLEASE HELP CHECK THE FOR SALE FORM FOR DETAILS THANKS JOE R, PS THANKS FOR THE INPUT ON THE BOW RAIL ITS OFF.

[Trayder]

Roger, let me give the guy who redid mine a call and find out where he is getting those. He redid a 23' last year that had replaced the rail and posts and it was the nicest I have ever seen. I'll ring him and get back to you on that one.

Is this what you are talkin about:



if so this is the firm that makes them:

E tec Marine

[Mark]

that be them.

[SEAFARI]

ContenderCraft [img]/images/graemlins/wink.gif[/img]

[Trayder]

Forgot the mention, that pic is courtesy of Seafari and as he mentions they are the same ones Contender uses.

Tx Rodney

[SEAFARI]

Thanks Jason,
Since we're talking recessed rails, The one I
used is 3/4 pipe, a little thicker than the
origional. With the E-tec stand offs, you can slide
them down the pipe so you can use the origional
holes. Also the cost of the E-tec parts and pipe
are only about 300.00. Its very important to bend
the new pipe exactly like the origionals!

[RS]

Thanks for the info. I've been in contact with E-tec. The fellow I spoke to said they were aluminum and the round needs 3/4 id pipe. This may not work for me since my fabricator already bought the 7/8 od tubing. I'll talk to him to see what can be done. If he can easily use the 7/8 on other stuff, I'll probably go with e-tec parts.