Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > General Discussion > Repairs/Mods.

Notices

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #12  
Old 07-28-2008, 12:57 AM
bkmoto786 bkmoto786 is offline
Junior Member
 
Join Date: Aug 2007
Location: Jupiter, FL
Posts: 10
Default Re: bracket

The Spec sheet does say deadrise degree (measured at transom) I misinterpreted it, sorry about that. I now understand that the deadrise is the angle of the sharpness of the bottom of the boat (v-bottom). Therefore a flat bottom boat has a deadrise of 0 degrees. I did measure my transom angle on my 18sf and it turned out to be about 15 or 16. Which coincidentally is the same degree deadrise listed on the spec sheet. sorry about my confusion, good luck
Reply With Quote
 

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 06:46 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft