Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > General Discussion > General

Notices

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #10  
Old 01-01-2009, 08:40 PM
Fr. Frank Fr. Frank is offline
Senior Member
 
Join Date: Oct 2003
Location: Shalimar, Florida
Posts: 2,265
Default Re: Help! My Seacraft sunk!!!

I have raised half a dozen boats in my life, from 16' to 40'. Take my advice, do NOT tow it submerged unless you cannot pump her out. Lots of bad stuff can happen.

If you can, use a minimum of 2 boats and 4 divers to aid the recovery, each boat anchored fore and aft on either side of the sunken vessel.

If you have a cuddy on the sunken vessel, a twin-sized air mattress inflated half-full provides good lift from in the cabin it doesn't help at the surface, though.

Tied under the hull, inner tubes make great inexpensive lifting bags. Use at least 5 inner tubes and better yet use 7 -
1 at the bow tied to the bow eye,with NO scope
2 tied to the stern eyes, with NO scope on the lines
2 lashed under the hull by 8' of line, fixed about 2' forward of the transom. When inflated, they should be attached so as to be fixed just 4"-6"above the hard-chine.
If you use 7, fix the last 2 lashed under the hull amidships.

If you have transom cutout, you need to lift the stern higher than the bow, so you can pump it out. You can rent 1 or 2 small gas-powered trash pumps at Taylor rental, which makes it easier.

With the gunnels and transom above water, continue pumping until the boat is as high as possible. Tow the sunken vessel in an alongside tow lashed to BOTH recovery vessels, OR astern with a tow line at least twice the length of the vessel being assisted, and a very sharp knife close at hand.

I'll add more later. Start your planning with this.
__________________
Common Sense is learning from your mistakes. Wisdom is learning from the other guy's mistakes.

Fr. Frank says:
Jesus liked fishing, too. He even walked on water to get to the boat!

Currently without a SeaCraft
(2) Pompano 12' fishing kayaks
'73 Cobia 18' prototype "Casting Skiff", 70hp Mercury
Reply With Quote
 

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 07:32 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft