Compression Question????

[fdheld34]

Thaks Tim..spoke with him 2 minutes ago on phone..not using o ring heads on rebuild..says he stays away from them...doing total teardown and rebuild back up to specs, including carbs..eliminating oil injection..and using block off plate??-- and said will look like came from factory..no extra wires etc for oil injection. He is going to pressure test lower unit and if any problems will also go through that as well. Also gauges hooked up and quicksilver binnacle control mount.(said he will not charge for rigging)
He is also going to pull head off for me on johnson and give me his opinion before this whole deal takes place. will repost next monday...gotta go to MS for thanksgiving..hate going out there..havent seen father in over 2 years and he always looks older every time I see him ...and he tells me I look fatter!!!!
I will start new thread regarding this due to only 2 thread at a time on this topic....just remember this is on a Mako ...hopefully not for long!!!
Tim....GUESS $4000 could buy me "BIG RED"

Sandy....still have your gps ...your outriggers look tempting.