3.0L merc efi

[eggsuckindog]

240 for boring all 6 .015 over as long as that 1 will clean up OK - just have it bored before you buy pistons, the guy will do it until its good - maybe .030 maybe not. Be sure and put Chris Carson Reeds in it best 120 you could spend - tell them i sent you, great guys to work with - their in Key Largo and will answer some rebuild questions too. I put a new oil pump and gear in just because of hours but thats optional about 250. The rest on the mains and seals are all minimal and you can get everything from Pro Marine and shipped to you via Mike@American Marine. I have a whole parts list with prices for a 2.5 but should be close, or go to Pro Marine on the net - those are list prices though not yours.

[Blue197320]

240 for all 6 is alot better than i was thinking. i was fearing 100 per hole. a set of pistons on promarines website was 700 with rings. so im thinking a little over 1200 to rebuild? what do you think about putting all new bearings in it? i probably should since im in there right?