Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > General Discussion > Repairs/Mods.

Notices

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #4  
Old 04-04-2010, 10:13 PM
gss036 gss036 is offline
Senior Member
 
Join Date: Jul 2003
Location: Bellingham, Washington
Posts: 260
Default gss036

I did my 1989 23 WA last year. It has the step up for the seats. My tank was a 115 gallon tank. It was 28 inches wide X 100 inches long and I think 12-14 deep. After removing the 2 deck plates and unhooking everything and getting the fuel out and putting in water and draining that, I measured up the tank, the deck hole was 27 inches wide, so I had to take 1/2 inch off of each side. Then tried pulling the tank back and out, it would not come out without removing my 225 HP Honda engine and I was not going to try that so I used a sawzall and cut about 3 feet off the tank and then it came out. I had a tank made, but went with a 75 gallon tank and that fit back in pretty easy. Lot of work, but now have a new fuel tank, new 225 Honda and a new T9.9 Yamaha kicker.
__________________
Gary
Reply With Quote
 

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 04:28 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft