1977 20ft Master Angler Restoration

[Seacraft84]

Thats a good idea. I will do that first thing this evening. Hopefully nothing is off to bad and I can get it corrected now.

Thanks again.

[Seacraft84]

Well everything seems to be good to go. Pulled some strings and they layed on one another just right with either one on top. Also rough cut a bulkhead for the front, where the anchors will be stored. Maybe Saturday I can get the floor screwed down.

[Seacraft84]

Got the floor screwed down and the anchor locker cabosiled in. I will sand it down tomorrow and lay the glass this week. The top cap is still loose, thats why it looks uneven.

[Seacraft84]

Sanded it down tonight and filled the last couple of low spots.

[Seacraft84]

Dry fitted the glass tonight. I will get it glassed in tomorrow night. Also made some molds for the rigging and gas lines.

[Wildman]

What size PVC did you use? Did you have to trim the slots in the stringers a little to get it to fit?

[Seacraft84]

It is 3". I sanded all the high pieces of glass that were in the way. It was a tight fit and you had to push it down in there. But I do not think with it being in there tight would cause any trouble. I put some cabosil on top of it, mainly because I had some extra. I also drilled about 6-7 holes in the bottom of it on each end in the event water got down inside it because it is not going to be sealed up at either end.

[Seacraft84]

[Seacraft84]

Sanded down the transom and fitted the molds.

[basswacker]

What is the purple puddy type stuff that you used?

Basswacker