Hi everyone had some free time today to investigate my controls. I found that the linkage was binding up on the plastic mounting block on the console. I was able to shave some of it down no more friction there. I also checked cables on the motor end, found that i have one inch of play on the bottom cable and half inch on the top cable. I was able to adjust it enough to get my carbs to open fully, but i cannot get them to open up full in reverse. I ran motor on muffs the idle is right where it should be and it shifts fine both directions. I will sea trial tomorrow to see if this works. I will keep posting my results. Thanks again guys!
|
10-26-2011, 04:25 PM
Threaded Mode