Hatch replacement/Bilge cover

[capnkid]

Guys,
Need some help. Have a 21' seacraft(2000...hope can still get help here) need to replace the bigle/engine deckplate. It is a 10x20" hole right on the transom infront of the engine. Has anyone replaced this/have any suggestions as to where to look to find a new one?

Thanks

[wattaway2]

just looked at the Lewis marine catalog Tempress makes a 91/2 x191/4 id and13x231/4 od that may fit

[bj]

If it's like the one on my 2003 21' I think it is made by Armstrong, although I could not find them on their website. Does it have two screw down knobs with the big arms underneath that tighten up against the splashwell?

[FishStretcher]

Originally Posted by bj

If it's like the one on my 2003 21' I think it is made by Armstrong, although I could not find them on their website. Does it have two screw down knobs with the big arms underneath that tighten up against the splashwell?

I just bought one, but I can't look at what it is (lewmar?) until the weekend. I want to say 9"x13"

[capnkid]

Thanks for the replies and the help. It was made by armstrong....I didn't see it in their catalog either which is why I inquired for the help. I picked up the phone and called them......shipped out a replacement same day.

[FishStretcher]

I just bought a Bomar hatch for that same reason for a 20 footer. I should install it this weekend. Can look up the part number then