I got all my rod racks fabricated out of starboard & ready to install but when I pulled the original teak racks I noticed that all the screwes were driven in at an angle . It must have been done for a reason because they are all the same on both sides & I'm wondering if this is a common procedure to create more bite with the screw.
This may sound stupid but I don't know if I should drill the new once straight or do them in an angle like the originals.
Last edited by sidelock; 06-13-2012 at 09:22 PM.
|
06-13-2012, 05:14 PM
Threaded Mode