Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > General Discussion > Performance

Notices

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 07-16-2012, 08:56 PM
eggsuckindog eggsuckindog is offline
Senior Member
 
Join Date: Mar 2003
Location: Tampa
Posts: 2,354
Default

First of all he asked


The WOT RPM does allow to figure that, or you could get a 13" prop and the motor wouldn't work hard at all - just wouldn't go very fast at cruise. Actually a motor over propped will cruise at a faster mph just like overdrive in a car but hole shot would suffer. So it is a balancing act since we don't have transmissions and RPM at WOT is the best way to determine it.

I am a good example - my cruise when the motor would only turm 5300/5400 WOT was /26/27/28 @ 3400/3600 - by raising the motor and now getting 5600 WOT my cruise increased to 28/29/30 at the same RPM depending on water conditions. I also found it stays on plane and sounds much better at 3000/3200 than it did before - which is good because 29/30 is pretty quick for cruise and I find myself pulling back to 3000/25 much more which it didn't really want to do before. BTW the 52 is close to 4/5 mph at WOT higher than before - which is fun when I want to feed it and according Ridge Runner floats like a butterfly

Thats why I suggested you try my prop, its a bit big but should give most everything as far as feel except WOT RPM - the feel factor was very noticable even before I raised it.
__________________
Any way you measure it - dumbass is expensive

Last edited by eggsuckindog; 07-16-2012 at 08:58 PM.
Reply With Quote
  #2  
Old 07-17-2012, 08:14 AM
RidgeRunner RidgeRunner is offline
Member
 
Join Date: Jan 2012
Location: Lakeland,FL
Posts: 57
Default

Sting like a bee there ESD.
I think a large diameter big blade 15P like the Mirage would do it for the Seafari with the 2.5liter 175 Opti. Maybe a 17 Stiletto or Tempest. Post them numbers Whitly.
I got an education on props. I could turn a 19p Quicksilver to 5800 RPM on my boat or a 17P Mirage at 5800. BUT a 17p Quicksilver was the fastest WOT overrevving to 6100. Blade design and diameter make a huge difference. Ken at PropGods is one way to go about testing before you buy. Wealth of knowledge there..
Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 01:26 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft