Back In The Saddle Again!

[strick]

Gil-

Sorry I was half asleep last night. Scrap and teak should not be used in the same sentence. Yes it it oak veneer I believe 3/16" or 1/4" I will take a look. It was laying in my scrap pile. The two smaller dash panels have 4 pieces of 1/4" teak glued to the surface of the oak veneer.

The motor has the slots already built into the mounting bracket. There is one more hole below the slot as well. I will take a close up pic and post it.

Dave- do up a kitchen thred and post it for us I dont know when it will be ready....maybe in another month? or sooner? I'm just taking it nice and slow now as I don't want to screw up the rigging. I'm not very mechanical inclined and it intimidates me.

strick

[fdheld34]

Chuck looks great!
What type of sealer or varnish did you use on the teak?
-Fred

[strick]

Originally Posted by fdheld34

Chuck looks great!
What type of sealer or varnish did you use on the teak?
-Fred

Fred it's the same stuff that I used on the 25 called Cetol. Three coats sanding in between.

http://www.gandermountain.com/modper...ID=GSHOP_81847

strick

[Islandtrader]

Originally Posted by strick

Gil-

Sorry I was half asleep last night. Scrap and teak should not be used in the same sentence.

Scrap Teak...I have one piece that I have been saving for the last 39 years...

Looking real good!