![]() |
|
#1
|
|||
|
|||
![]()
1st coat of primer. Not perfect by any means but plenty solid.
![]() |
#2
|
|||
|
|||
![]()
My new toy, garmin 740S with airmar 20 degree tilted thru hull. P.S. 100 bucks off starting March 7th at WM. and the $300 fancy card is only gonna be $100 with mail in rebate.
![]() |
#3
|
|||
|
|||
![]()
I removed an old transducer tonight and will put the new ducer in the same spot after I drill a larger hole. The hull thickness in the location is about 1/4 inch. Is this thickness about right for the 20s? The hole is about 18 inches forward of the stern starboard side of keel by about 6 inches. The old ducer was so old the wire had either rotted off or been cut at some point. Any one recognize the make of transducer and its approx age. There was a transom mount ducer which was being used when I bought it.
![]() ![]() |
#4
|
|||
|
|||
![]()
Got the engine hung. Which means the transom is done done. I still need to get the extension kit. Right now the cav. Plate is 4 inches above the keel, so I'll probably taise the engine up 2 maybe 3 holes.
![]() ![]() Then instal tank, run wires and finally do the deck. |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|