1974 20' sceptre transom replacement and i/o to outboard bracket conversion

		Classic SeaCraft Community > General Discussion > Repairs/Mods.
1974 20' sceptre transom replacement and i/o to outboard bracket conversion

#10

10-22-2013, 05:51 PM

Blue_Heron Blue_Heron is offline

Senior Member

Join Date: Jan 2006

Location: Gator Country

Posts: 1,416

I think the rule of thumb is a 1:12 taper when you grind it back. So if the laminate you're splicing is 1/4" thick, you would grind it back 12/4" i.e. 3" on each side.

__________________
Blue Heron Boat Works
Reinventing the wheel, one spoke at a time.

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

All times are GMT -4. The time now is 05:25 PM.