Structural Support Topside '23 Tsunami

[abl1111]

Jim,

I've always liked your pipe layout. Very robust. I'm trying to figure out a definitive way to tighten it all up without making it look like cr*p. Not exactly sure where the play comes from - yet.

[FLexpat]

I think you could use some 1/4" or 3/16" plate as a gusset. You would have to bend it to match the curvature of what is already there but it would really stiffen it up and still not look like a stupid add-on. Go about 6" on the vertical piece and wrap around the edge of the horizontal bend. Don't do it as just a triangle, add some curvature to make it look like you planned it.