engine height df140 on SF20

[Capt Terry]

My ETEC was as high as it would go (on holes probably drilled by the ETEC dealer).. it was pretty good at this position. When I redid the transom I raised the engine another 5/8” - 3/4”, where ironically it was about dead nuts with earlier holes for my Merc, drilled by Frank Brown. Frank was Moesly’s race mechanic snd my dealer for my SeaCraft and first two Mercs. At the new position I am where I need to be RPM-wise. Haven’t run it too much, think I am happier at this position, but left room to drop it one hole.