Extreme makeover 72 seafari 25 aloha edition

[Xcomunic8d]

Here’s the port light with 1/4” smoked plexiglass in it. I used double sided tape and a flush trim bit to duplicate it. About 3’x6’ piece if memory serves.
siliconed in place and held down with clamps.
Tp-139 was installed. The corners are tricky. And my original ones had silicone in the corners.

Got 20’ of tp-139 @ $7/ft. from these guys. Call and ask for American marine.

https://pompanettellc.com/
603-826-5791
You need the inv number to duplicate orders. Pm me if anyone needs it. It only cost me $30 shipping and shipped faster than quoted.

[Xcomunic8d]

and here is the plan for the gauge cluster

i have a piece of curly teak picked out and ran it through the flush trim router to make a duplicate of the original (or a least a copy of a copy now).



Any suggestions, please let me know. I intend to put a seacraft emblem at the top over the large (speedo and Tach gauge in middle like factory). I'll probably have MPO make it for me. I'm not positive if these are spaced quite right yet. only thing i can do is print and make some templates on scrap and see how it looks.

I'll post more pics as I get this done hopefully this week schedule permitting.

2 large are speedo and tach
then 2 fuel, volt, tilt, temp, oil
small in bottom middle is check engine light

[Capt Terry]

Hey X
FWIW, I have two bilge pumps on my 20’ Seafari with small lights on dash when they are operating either manually or automatically
I like knowing visually when the pump is on.