![]() |
|
#1
|
|||
|
|||
![]()
Bryan … This fuse block is going to feed everything on the boat ? Or are you going to change out switches ?
Blue Sea Weatherdeck panels seem to be the latest thing ( in either no fuse, blade fuse, and now circuit breaker.) Labels are back lit for circuit ID , to tell you if they are on or off and to tell you if the fuse is blown. They use Carling switches( I think are pretty good) which can be swapped out and changed for $5-7 a pop…. on/off, on/off/on, momentary on/off …and on and on. I like the fuses as they are simple to change( and inexpensive) if they pop !! The circuit breaker is pretty nice too but more money and if one goes bad …then what. A backup of each breaker might get expensive. Just something else to think about and an opinion I realize this is probably more than you are looking for … given how I *think* your going to apply it. I just got one and they look very well built. |
#2
|
|||
|
|||
![]()
I would like to route all power throught this panel. I would also like to eliminate all the exterior switches that I can. It is easy enough for me to reach into the cabin from the helm and turn things on. This should clean up the dash. I think I'll leave the horn and big bilge pump on the dash and put everything else inside. That panel looks cool, how much did you pick it up for? Mine dosn't have to be waterproof but I like the switch panel. I was going to make up my own panel on mohoghany plywood inside the companion way since I already have all the switches. As you see from the pic anything is possible at this point. Thanks for all the suggestions so far.
__________________
May all your deadrise be variable. My 1973 SeaCraft 20SF Parker 2530 DVEC Boston Whaler 15 1984 |
#3
|
|||
|
|||
![]()
Dash pic test. I'm trying to figure ot this MAC.
![]()
__________________
May all your deadrise be variable. My 1973 SeaCraft 20SF Parker 2530 DVEC Boston Whaler 15 1984 |
![]() |
|
|