Please post your wiring pictures.......

[Old'sCool]

For those that have reworked, neat wiring and panels you're proud of please post pictures to give some ideas. The Contenders probably have the best I've seen so far.

[Blue197320]

i hope there are some good examples shown. this will be beneficial to me as well soon..

[toddslures]

I will be starting this process hopefully in December and will post what we are doing. I am having my wire printed for each application.

[Rich]

I have the wiring schematics for the silverhawk boats. I'll scan them in and see if i can post them. The original builder sent them to me probably over two years ago, just have to mention that they were originally drawn by Mike Witte.

I'll try to find them..

[TUGBOAT]

Here Ya go!
All #'d, crimped,Di-Electric greased,Heat shrinked.



Before




After

Scream'n Reels'

[warthog5]

There is a bunch more than this in my boat. It has a bunch more system's than the average 23ft boat.





NEMA box. Not hooked up yet in that pix.

[Old'sCool]

Nice Warthog!!

[Miles Offshore]

Nice work warthog- tell us about the nmea box- looks like what I need- those tinnie wires are difficult to route especially when in the same sheath with the 12vdc main power wire. With a center console and a whole lot of systems and very little space to put them all it is very difficult to make it look as clean as your set-up. I sure tried on mine- Brad- you sure did a sweet job on yours too. It makes the appearance look better when you can get your wiring away from your dash gages and motor wiring . I have all coming together in the same spot ,engine wiring,gage wiring, including all the wiring coming out of the t-top, electronics, antennaes,etc etc etc. what a mess. stranger!!!!! craig

[Old'sCool]

Couple of ?'s Wartog. What's on the Racor side of the fuel line before the bulb? Do you have a pic of your switches? What's the "power pak" thing under the rear cap?

[RUSTYNTABATHA]

AWOSOME JOB WARTHOG.