![]() |
|
#1
|
|||
|
|||
![]()
first, none of the 70's motors were rated at the prop, that didn't come into being 'till the 80's.
I run an 83 Johnson V-4 115, plenty of get up and go, nice 25 mph cruise, 30+ top end. and light. motor weight on a 20 makes a difference, the V-6 200 will be squatting in the stern at rest, but you sure won't have to work the motor hard to go fast. the 125 Force ought to be fine, too. Bill |
#2
|
|||
|
|||
![]()
Thanks to all for responses. I want to get out on West Bay and near offshore Rigs ASAP. So I'll be using the 200 ( if it passes inspection
![]() Anyone want to trade ? |
#3
|
|||
|
|||
![]()
Amen to Bill's advice! I ran the same rig for over 30 years with a 115 V-4, including 6 trips to the Bahamas. I believe the boat will generally ride better with the lighter motor. I couldn't cruise as fast as the V-6's in flat water, but it's always choppy on the Bahama Bank, and I had no trouble staying with them when it got choppy. What you have to remember is that the 20' hull is relatively narrow compared to newer boats, which is one reason it rides so well! When it was designed back in the mid-60's, the biggest motors available only weighed about 300 lbs.
As motor weight goes above that the boat becomes progressively less well balanced IMHO, especially the sf/cc which is more stern heavy than the Seafari to begin with. With my old 1975 115 I could plane at 12-14 mph which is nice capability to have when it gets rough; I suspect min planing speed is a fair amount higher with a heavier V-6. Avg mpg on the Bahamas trips was 2.8 mpg with very heavy load. It's about 4.5-5 mpg with the new motor but you can't justify cost of a new motor based on fuel usage alone, even at $4/gal! ![]() ![]()
__________________
'72 SeaFari/150E-Tec/Hermco Bracket, owned since 1975. http://i188.photobucket.com/albums/z...Part2019-1.jpg |
![]() |
|
|