|
|
|
|
#2
05-22-2010, 04:48 PM
|
|||
|
|||
Re: 150HP Johnson
Just a thought, the rubber diaphrams and seals do not like to sit dry, how about filling the carbs and fuel system with a stabil treated gas. When you are ready just pull the bowl drains and pump some fresh gas through the fuel pump and carbs - thats what I'd do. Not sure which is worse, leaving them dry or dealing with this gas, so thats a solution anyway.
__________________
Any way you measure it - dumbass is expensive 
|
|
#3
05-23-2010, 10:20 PM
|
|||
|
|||
|
Re: 150HP Johnson
That might be a good idea. I already noticed that there is a gas leak. I can see it is coming from around one of the gaskets. I hope theres not too much damage from sitting too long. I am going to wait until I mount it on the boat to take it to get serviced. I have got the new stern laminated in and we are going to glass it in this week. The rebuild should start flowing now. I will start a thread in the repairs/mods forum with some pics of the progress.
__________________
1975 Seacraft 18SF w/2004 150hp Johnson 2-stroke on a 26" bracket
|
 |
|
|
Hybrid Mode
