1974 20' sceptre transom replacement and i/o to outboard bracket conversion

[flyingfrizzle]

Quote"Nice work - should be a sharp looking rig! Ever thought about putting hinges on that board and making a hatch out of it where the old engine box was? Seems like that might make a handy storage space under the deck?"

It is fully glassed in now at this point but I made it beefy so that I can cut an access hole in the floor panel and it will be plenty strong even with a hatch cut into it. I more than likely will make a hatch for it, but not sure yet. I have a nice new abs plastic o-ring sealed factory made add on hatch that came with the master angler that was never used but think I rather make a custom fiberglass one.

[flyingfrizzle]

Here are a few pic's of the rear liner/cap coming back together:










Here is a few Pics of the fuel cover getting a new coring: