Classic SeaCraft Community

Page 2 of 2

Show 40 post(s) from this thread on one page

Classic SeaCraft Community (http://www.classicseacraft.com/community/index.php)

- Performance (http://www.classicseacraft.com/community/forumdisplay.php?f=5)

- - Deck drains (http://www.classicseacraft.com/community/showthread.php?t=14728)

pogden

09-22-2004 10:09 AM

Re: Deck drains

Smoker,

Can you post a pic of your drains out the side??
I'm going to be redoing the drains and I'm still not sure what is best.
Thanks

warthog5

10-15-2004 12:44 PM

Re: Deck drains

I don't care for the Rabuds. The T-H one's are better. They have a stop screw that you back out a little and then you can give a 1/4 twist to remove them and clean the ball when it get's dirty. With the Rabuds you have to remove all the screws and unbed them.

http://www.classicmako.com/projects/xshark/bw33.htm

RS	10-15-2004 03:03 PM

Re: Deck drains

Quote:

I don't care for the Rabuds. The T-H one's are better.

I like the slightly smaller rabuds better because the T-H scuppers have too much room in the clear case. At rest, the very slight pressure allows the ball to float off of the hole, allowing water in. I made the switch, and wish I hadn't. Now I usually plug the rear drains to keep water out.

Reel Smoker

10-16-2004 11:52 AM

Re: Deck drains

Pogden, I was refering to the drains for the corner compartments on the transom, not the scuppers. Sorry for the misunderstanding.RS.

All times are GMT -4. The time now is 05:05 PM.

Page 2 of 2

Show 40 post(s) from this thread on one page