Classic SeaCraft Community

Classic SeaCraft Community (http://www.classicseacraft.com/community/index.php)
-   General (http://www.classicseacraft.com/community/forumdisplay.php?f=4)
-   -   water in fuel (http://www.classicseacraft.com/community/showthread.php?t=14809)

runamuck 10-17-2004 09:19 AM

water in fuel
 
I have a 1998 21cc Seacraft & I am having trouble with fresh water getting in the fuel tank.I have checked all lines & fittings & they are OK. The fuel tank vent is attached to the fuel fill with a vented fuel cap.I think this set up is my problem. Looking for advice

Mark 10-17-2004 02:49 PM

Re: water in fuel
 
A friend with a year 2000 20' Master Angler had the same problem. The cause of his was determined to be some rather creative routing of the fuel and vent lines: in rough conditions, he took a LOT of water into the fuel tank [img]/images/graemlins/shocked.gif[/img]

ScottM 10-18-2004 08:38 AM

Re: water in fuel
 
runamuck,
Do you have a fuel/water separator? If not, it's a good idea to install one even if you still have to re-route the fuel and vent lines. This way you can be fairly certain that contaminated fuel won't get to the engine. Another way to prevent/detect water in your gas is to install a sending unit from WEMA , which will detect water before it gets from the tank to the water separator. Plus, you'll get a much more accurate reading on your fuel gauge.

FELLOW-SHIP 10-18-2004 08:49 AM

Re: water in fuel
 
The fuel Vent line should have a U shape in the hose allowing water (if any water can get into it from the ocean) to be trapped in the U it kind of looks like this.
boat vent location ----- U ------ inside location of hose (the U should be located lower on this example)

This belly of the hose traps water in the U and keeps anything from intering into the tank.

FellowShip [img]/images/graemlins/grin.gif[/img]

RS 10-18-2004 12:47 PM

Re: water in fuel
 
Quote:

The fuel Vent line should have a U shape in the hose allowing water (if any water can get into it from the ocean) to be trapped

I'm pretty sure it's the opposite. The vent line needs a riser loop to prevent water from entering the tank. Accumulations of water in a trap will ultimately be sucked into the tank.


All times are GMT -4. The time now is 04:02 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft