Forum: Recovered Threads
03-06-2017, 08:52 AM
|
|
Replies: 8
Views: 69
|
|
Forum: Recovered Threads
03-05-2017, 01:41 PM
|
|
Replies: 8
Views: 69
|
|
Forum: Repairs/Mods.
09-09-2011, 09:16 AM
|
|
Replies: 19
Views: 1,006
Re: Ideal Dual-Bilge set up for 20' Seafari
one pump higher than the other applies to auto pumps, if they were both std./manual pumps then both in the same area with float switches at different heights in the bilge so you're only using the...
|
|
Forum: Repairs/Mods.
05-12-2011, 10:12 AM
|
|
Replies: 6
Views: 534
|
|
Forum: Repairs/Mods.
04-12-2011, 04:00 PM
|
|
Replies: 19
Views: 305
Re: Foam
i've poured both 2 & 4 lb/cf foam and the foam I pulled out of my boat around the tank sure felt like 2 lb/cf.
|
|
Forum: Repairs/Mods.
03-07-2011, 11:39 AM
|
|
Replies: 18
Views: 763
Re: Epoxy vs Vinylester
poly & vinylester are fine on a new build, when laminating wet on wet layers of material, but you'll never get as good of a bond onto something thats already cured. Thats where epoxy has such an...
|
|
Forum: Repairs/Mods.
03-03-2011, 12:07 PM
|
|
Replies: 18
Views: 763
Re: Epoxy vs Vinylester
I'd vote for epoxy, have used both and it always seems that the accidental drops of epoxy are stuck to whatever they land on better than vinylester, ie you can usually chip a stray drop of vinyester...
|
|
Forum: Repairs/Mods.
03-02-2011, 03:35 PM
|
|
Replies: 15
Views: 244
|
|
Forum: Repairs/Mods.
02-15-2011, 03:51 PM
|
|
Replies: 5
Views: 302
Re: pinch molding
try these links, might have what you're lookin for:
http://greatlakesskipper.com/category-1/5_320_323-boat-deck-and-docking-hardware-trim-lock.html
http://www.go2marine.com/product.do?no=42262F...
|
|
Forum: Repairs/Mods.
01-21-2011, 10:36 AM
|
|
Replies: 104
Views: 8,904
Re: 1977 20ft Master Angler Restoration
the boat is looking good, lot of work into it so far.
I've got a comment about your fuel tank...When I bought a Moeller tank, also plastic/cross linked poly like yours, they say to leave an inch gap...
|
|
Forum: Repairs/Mods.
06-29-2010, 05:46 PM
|
|
Replies: 10
Views: 190
Re: Resin Question??
I've been using Glue Products in west palm beach, fl, 561-833-1863, for a long time. Never had an issue with their resin, epoxy ends up costing around $38/gal for the 1:1 or 2:1 mix, not sure if...
|
