Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > Search Forums
Reload this Page Search Results
FAQ Community Calendar Today's Posts Search

Notices

Showing results 1 to 11 of 11
Search took 0.00 seconds. Search: Posts Made By: jondavies
Forum: Repairs/Mods. 04-22-2013, 09:02 AM
Replies: 14
Views: 634
Posted By jondavies
On deck extension, take a look at Speed Rail for...

On deck extension, take a look at Speed Rail for the frame: http://www.hollaender.com/index.cfm?fuseaction=home.viewpage&page_id=EC24FDAE-CC9C-BA86-D8D542E83A8C403F

3/4" aluminum tubing will more...
Forum: Repairs/Mods. 04-06-2013, 08:03 AM
Replies: 14
Views: 634
Posted By jondavies
Just out of curiosity, where was the carpet on...

Just out of curiosity, where was the carpet on the MA? The only carpet on mine was in the bow locker and I took it out (along with about 10lbs of sand).

Rusty - could you post up pics of your bow...
Forum: Repairs/Mods. 04-04-2013, 05:43 PM
Replies: 20
Views: 930
Posted By jondavies
I've reinforced the foredeck with a triangular...

I've reinforced the foredeck with a triangular section of ply glassed under the deck and I'm going to distribute the load of the anchor roller by mounting it to a section of Starboard on top of the...
Forum: Repairs/Mods. 03-31-2013, 11:55 AM
Replies: 20
Views: 930
Posted By jondavies
I ordered some new teardrop LED lights (not quite...

I ordered some new teardrop LED lights (not quite flat - they're about 2" high) but I'm not sure where to mount them.

Based on the size, they could either go above the rubrail just aft of the bow...
Forum: Repairs/Mods. 03-28-2013, 06:37 PM
Replies: 20
Views: 930
Posted By jondavies
Thanks -- I'll move the bow light. What...

Thanks -- I'll move the bow light.

What replacement lights and placement do you recommend?

Any pics would be helpful.
Forum: Repairs/Mods. 03-28-2013, 03:46 PM
Replies: 20
Views: 930
Posted By jondavies
Anchor roller configuration

I want to add an anchor roller to my SeaCraft so that I'm not hauling the rode and ground tackle over the gunwale and scratching up the protector below the cleat all the time. I'm not planning to...
Forum: Repairs/Mods. 03-12-2013, 02:58 PM
Replies: 1
Views: 246
Posted By jondavies
Adding a drain to the fuel tank well

I pulled the fuel tank out of my new-to-me Master Angler and other than some nasty, cruddy gas that I'm flushing out, it doesn't look too bad. The tank was sealed with epoxy and the foam around it...
Forum: General 02-23-2013, 01:00 AM
Replies: 17
Views: 747
Posted By jondavies
Thanks Brett - that's a beautiful restoration. If...

Thanks Brett - that's a beautiful restoration. If you were closer to So Cal I'd be all over it.

There are soooo many nice boats in North Carolina. So many infact, that I've looked into shipping a...
Forum: General 02-21-2013, 09:04 PM
Replies: 17
Views: 747
Posted By jondavies
Thanks for the sage words, guys. I heard...

Thanks for the sage words, guys.

I heard through the grapevine from someone who'd looked at it that there's a fair amount of internal rot so I'm going to pass ... not that I'm a chicken or...
Forum: General 02-21-2013, 05:03 PM
Replies: 17
Views: 747
Posted By jondavies
The seller is asking about $7500 but my target...

The seller is asking about $7500 but my target price is closer to $5000 if the boat is structurally good. Reasonable?

Thanks for all the feedback! I'm looking forward to becoming a member of the...
Forum: General 02-21-2013, 01:30 PM
Replies: 17
Views: 747
Posted By jondavies
'79 Master Angler 150 Mercury

I'm looking at this boat tomorrow and would appreciate any thoughts from those who know more than me about Sea Crafts.

It's obviously due for a repower and could use a galvanized trailer but if...
Showing results 1 to 11 of 11

 
Forum Jump

All times are GMT -4. The time now is 02:35 AM.

Contact Us - Classic SeaCraft Home - Archive - Top

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft