[billythekid]

Gome some work done after real work this afternoon.I put the console down on a piece of formica to laminate against. I laid up the flange on the inside the console with 3 layers of 1708 and a 2 layers of mat. It was a pain in the ass to work inside the console laminating. I taped the outside of the console and went to work






popped it off the formica. out came the diamond tipped router blade and it made shrt work of the flashing.





I left a little over 2 inches to screw through




after adding a couple more mounting points inside the console I decided I wanted it white on the inside. so I taped off all the holes and mixed up a quart of epoxy primer









tomorrow is paint in the inside then I can non skid the floor and rig the inside of the boat.