Hey All,
I have finished Phase I of my Project. That was to Re Power to replace blown motor, Replace fuel Fill and motor main fuel line from tank, Install Fuse Box, Water Separator, Replace broken Binnacle Control Box, Throttle and Shift cables, Red Plug wiring harness, Bilge Pump, and steering Helm unit and cable. All went well EXCEPT that after remounting Console I was pulling old brittle wires out of the conduit and I pulled the Fuel Sender wire back into conduit...ARGGG ! I tried to fish it but havent been able to get it yet. Heres my question
Without removing Console again and accessing sender under the deck hatch how can I possibly retrieve the wire, and if I cant, would cutting a round access panel in the hatch to get to the sender be wise/stupid ? I would need to know WHERE the sender is located and cut my hole over it. I REALLY want a fuel gauge. Thanks in Advance !!
Dave
PS: Fr Frank and Bushwacker. You were right. That 90 HP Johnson pushed me 34-35. Plenty hole shot for me.
