The Kiwigrip gives a nice even texture. you have to pull the tape off while its wet
i moved the boat outside and did 3 rounds of sanding (many hours) with a DA sander. I started with an 80 grit, then a 180, finally a 320
I moved the boat back inside and created a much bigger poor mans paint booth
Eveyrthing got taped off
I shot on a couple of coats of paint. Everything was done except the floor. I need a little more sanding and fairing before putting down non skid
I ordered my console, should be here this week. Next weekend i hope to set the tank for good and close up the main hatch. I still need to buy controls for my engine. I hope to cast a line from this boat by June. Stay tuned i hope to move quick on this project.
-Mike