|
|
#16
04-01-2012, 02:50 PM
|
|||
|
|||
The Kiwigrip gives a nice even texture. you have to pull the tape off while its wet
  i moved the boat outside and did 3 rounds of sanding (many hours) with a DA sander. I started with an 80 grit, then a 180, finally a 320  I moved the boat back inside and created a much bigger poor mans paint booth  Eveyrthing got taped off  I shot on a couple of coats of paint. Everything was done except the floor. I need a little more sanding and fairing before putting down non skid   I ordered my console, should be here this week. Next weekend i hope to set the tank for good and close up the main hatch. I still need to buy controls for my engine. I hope to cast a line from this boat by June. Stay tuned i hope to move quick on this project. -Mike 
|
|
|
Threaded Mode