A New Boat to Check Out

[Bobv]

The floor was made outside of the boat using a pattern, seen here leaning up to the left. The underside has been glassed.



The top side of the foam core won't be glassed until in place. Cutouts were made for fuel tank and battery box access, as well as for the control and wire chases.



Floor bonded in place.



I plan to access the battery boxes, macerator pump, and tranducer through a seat in front of the console (the hole through the floor of the lower battery box in the picture is for the transducer tank). Access to the fuel tank and the control/wire chases will be in the console itself.