|
|
#1
10-04-2012, 09:20 AM
|
|||
|
|||
Inspection plates
I'm looking @ putting an in deck inspection plate over the fuel tank's sending unit .I would prefer a flush mount/water tight plate if at all possible. Any recommandations/suggestions on brand/type would be greatly appreciated.
Last edited by sidelock; 10-04-2012 at 06:58 PM. 
|
|
#3
10-06-2012, 08:35 AM
|
|||
|
|||
|
I assume you looked at Bomar?
I have one for the bilge, but I am not sure how a plastic one would be underfoot. The aluminum ones are probably to big and deep vertically. I don't know about the other models, but the 20 foot console models have very modest clearance from tank to deck. And I didn't think pulling up the entire panel was that hard?
|
|
#4
10-06-2012, 09:05 AM
|
|||
|
|||
|
It would seem that most of us would re-engineer our crappy designs to SC quality.
|
|
#5
10-06-2012, 11:08 AM
|
||||
|
||||
|
You can lift out your deck plate and cut your opening & config it for a flush mount. I have found the Armstrong brand are the best.
I have 2 of these in my deck. Also the ones used in my Hermco Bracket.   Link---->http://www.armstrongnautical.com/deckplates.htm
__________________
   1978 23' Superfish/Potter Bracket 250HP -------- as "Americans" you have the right to ...... "LIFE, LIBERTY and the PURSUIT of a Classic SeaCraft" -capt_chuck
|
|
#7
10-06-2012, 06:32 PM
|
|||
|
|||
|
Quote:
Diving tomorrow. This is getting to be a focus. Cheers, Me and my arrow
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
