Introduction

[NickGarrott]

Bikecop I will hopefully tie them in today. I was attempting to make 12-1 scarf joints and then sister a piece to each side. Unfortunately that is beyond my limited carpentry skills and patience. The current stringers have a 3" step in them for running hoses. I am going to fill this step in with a piece of coosa, and then sister a piece next to it. Everything will be grinded clean ahead of time, tabbed in with 20 oz triaxial, then overlaid with a couple layers of 1700. The pictures are of the mock up only, I want the butt joint to be 20x as long as the stringer is thick, so that sister piece to the side should extend at least 8 inches past the joint.