300hp Shaft length - Classic SeaCraft Community

		Classic SeaCraft Community > Recovered Threads
300hp Shaft length

02-28-2018, 09:03 PM

DonV

Senior Member

Join Date: Jul 2004

Location: Apollo Beach or Islamorada

Posts: 3,488

The clearance on a G2 when totally tilted up is like 29", maybe 28", from the mounting bracket of the engine to the wall of the transom, I'm not positive let me look. I'llsee if I can find the document from Evinrude.

OK I'm back, check out this post. Because the eTec tilts at 80 degrees you have to be careful for clearance. Looks to be right at 26". You should be good.

http://www.etecownersgroup.com/post/...id-339-8138819

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

All times are GMT -4. The time now is 08:27 PM.