Yamaha's VZ300 VMAX HPDI

ScottM · #1 08-14-2003, 10:59 AM

"Blew out my flip flop, stepped on a pop top, had to cruise on back home..." - Ed, just make sure you have a batch of Margaritas and you'll be all set [img]images/icons/grin.gif[/img] .

Trayder · #2 08-15-2003, 11:44 AM

Hehehe-

too funny, poor Ed leaking boat, blown flip flop, wacking his truck with a hammer!!!!

I have an idea just buy Trayder and be done with it, I will even throgh in a pair of flops.

If anyone knows someone interested in a 25-27 ft Center console Trayder is for sale again, I am showing her to someone next week but would very much like to sell, that Jazz fest trip was the first time she left the slip in 3 weeks and she only left said slip 6 times this season. [img]images/icons/frown.gif[/img]

Ed · #3 08-15-2003, 09:27 PM

Bring trayder over to nantucket for a couple of days with a few for sale signs on her. She'll sell in a minute and you'll have to fly home.

Craig Mac · #4 09-26-2003, 01:47 AM

Gentlemen the 300 VMax is in their 2004 line-up

http://www.yamaha-motor.com/products...ries&scat=HPDI

not sure a 20 inch shaft length is right for SeaCraft 23, any comments?

Briguy · #5 09-25-2003, 11:02 PM

The 20 inch shaft would work well on the '18 or '20 foot SeaCrafts. [img]images/icons/wink.gif[/img] [img]images/icons/grin.gif[/img] [img]images/icons/tongue.gif[/img]

gss036 · #6 09-27-2003, 08:38 PM

Craig, you would need a 30" shaft for a 23 ft Seacraft or 25" for twins.

John R · #7 09-28-2003, 11:24 AM

Craig - depends on your Seacraft. If it's stock and has not been raised, you'd likely have a 25" for a single or 20" if twins ...