|
|
#20
12-08-2004, 06:37 PM
|
|||
|
|||
Re: stringer pieces in place.
Looking good. I didn't know that you had even started the project yet. Shows how out of touch with the rest of the world . I'd highly recommend NIDA or even coosa for the floor, but both can get a tad bit expensive.
You can get the bare NIDA for about $50 a sheet. Figure 5 sheets will be the total for that hull. Then you are looking at at least one layer of 1808 on the underside and 1-2 layers on topside and lots of resin! 
|
|
|
Threaded Mode