Making progress, feeling stupid...

Finster · #1 01-02-2005, 04:10 PM

Otto, looks great.

Mark, who's winning in the 20 division?

warthog5 · #2 01-02-2005, 04:53 PM

George. [img]/images/graemlins/cool.gif[/img]

But I like the Black on Jim's. [img]/images/graemlins/cool.gif[/img]

Scott · #3 01-03-2005, 12:00 AM

Otto ...they did do a nice job on that hull ... betcha feeling good about it now !!
Question about the VC ... Did they go with that since your keepin her on the trailer and instead of putting Imron on the bottom?? thats not a commonly used "antifouling" paint around here (I believe sailboats use it for racing bottoms)....

Quote:

Mark, who's winning in the 20 division?

Three boats (20's) come to mind...two I've not seen in person
Hammer's ... I think made us all drool
Mark's ... Just the teaser pics put some of us over the edge .... Hope to see it this spring
Trayders ... I remember a "burban" full of us going to look at it as Scott(Viking marine) was riggin up the engine ... The boat wasnt even finished and there was SeaCraft envy !!
George ...Paint looks real good !!…hmmm that’s four

ocuyler · #4 01-03-2005, 09:15 AM

Scott,

Thanks. Tom and I had originally put on the VC-17 due to it's fresh water anti-fouling ability, contains Teflon so the boat will go "really fast" and is white, which is the look I wanted. Although intended as a trailer boat, It gives me the option of leaving her in the the water for a week at a time and still have easy clean up. We'll see about that...

PipeDreamsMarine · #5 01-03-2005, 11:10 AM

Hey Otto.. How are you going to get that nasty looking blemish out of the side? Seeing that you paid to have someone do the work, I'd stop payment till they fix it. It's a shame. .boat looks great other then that blemish...

Scott · #6 01-03-2005, 11:10 AM

Otto ... Sounds like it will work perfect for your application . Thats probably a great choice for the rigors of on and off a trailer too ...

I bet when you do let her sit in the water for a bit any slime would wash right off since its got the Teflon in it. I see it is recommended for the lakes or areas of low fouling …again looks like a good alternative to a re-gel coat job.

One of the restorers in the area did spray the bilge of a 23 with it … Don’t remember why he used that over some of the other stuff out there …. Looked real nice …got fancy and fleck coated it

Is the final VC finish on your boat high gloss ??

ocuyler · #7 01-13-2005, 09:47 PM

Scott,

The final finish on the white VC-17 is more of a semi-gloss. It will finish better, but it's so hard that you'd have to work REALLY hard.

Abe's Rocket · #8 01-13-2005, 09:19 PM

you are correct about the VC-17 on sailboats...