Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > General Discussion > Repairs/Mods.
FAQ Community Calendar Today's Posts Search

Notices

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #6  
Old 07-19-2005, 07:13 PM
warthog5 warthog5 is offline
Senior Member
 
Join Date: Jan 2004
Location: Pensacola,Fl.
Posts: 789
Default Re: re-coating armstrong bracket????

Quote:
The coating is flaking because of electrolosis. I was planning on sanding it down, neutralizing it with a chemical product, and then priming and spraying it with awlcraft 2000. What do you think? I though about powder coating it, but I heard if you get a chip in the finish, it will have to be redone totally. That wasn't all that inviting.....
This is a perfect candite to have sandblasted. It will clean everything up and etch the alum in prep to hold the primer very well.

Here's some thing's to think about when you reinstall it.

Install a rudder style aniode on the tub/body. Be sure not to paint the small area that the aniode makes contact with.
Install Delren washers under your stainless washer's to isolate the 2 metal's. Coat the bolt's with Tef Gel.
http://wolfwire.com/tefgel/Tef-Gel.htm
Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 02:18 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft