Trim Tabs on 2004 23'

[DonnaSea]

Craig - are you back in the area for good?

Based on Ron's post, I am pretty sure they are Bennett. I have a leak in one of the hydraulic hoses (which I caused). I have ordered a new length of hose and hope to get it installed this coming friday.

Striper season is here and I can't have the boat out of service!

Did you get your boat put back together?

[Miles Offshore]

hi charlie- the boat is back in the water and did a maiden sea trial / fish trip yesterday. Went 2 for 12 on the rockfish (thought i was white marlin fishing, couldnt keep the hook in them- they were nice fish with the largest 40" and fat. The boat ran good- figured out a couple more items i need to square away before I run again- ( thats what sea-trials are for right!)I go to the MD on Thursday, think I have a torn rotator cuff in my shoulder and had MRI's done last week- hopefully no surgery. Have you talked to tabman about the tubing?? Im sure he can hook you up with some tubing pretty quick. He has a forum on that tht web site- is it soft tubing??? I dont know that Bennett uses soft tubing, its a flexable hard plastic tubing???? anyways-get her right- the cows are right off the beach now!!! get that speedster going!!! see ya - craig

[DonnaSea]

I did the rotator cuff thing - not fun. I managed to get through it with physical therapy.

I have been in contact with Tom - he offered to get me the tubing and fittings for free - nice guy. The tubing is hard/flexbile.

I have not been out after the stripers yet - other than the FM99 tournament that took place during gale warnings. I made one last attempt at Tuna out of Oregon Inlet yesterday - nothing but Fat Alberts.

If I get my trim tab fixed on friday, I'll see you on the water over the weekend.

[Old'sCool]

You'll find that Bennett and Tom offer some of the very best customer service there is.

[DonnaSea]

Tom has already shipped the parts. You cannot find customer service like that these days.