![]() |
|
#1
|
||||
|
||||
![]()
I'm over 3,000 miles away and it's like being right along you in your shop!
Your posts are the best "How To Book" on the web ![]()
__________________
![]() ![]() 1978 23' Superfish/Potter Bracket 250HP -------- as "Americans" you have the right to ...... "LIFE, LIBERTY and the PURSUIT of a Classic SeaCraft" -capt_chuck |
#2
|
|||
|
|||
![]()
I agree with CaptChuck......your photos are my how to....
only wish I was nearby to lend a hand.... [img]/forum/images/graemlins/tongue.gif[/img] |
#3
|
|||
|
|||
![]()
Well I'm not sure if it's the best how too but it is one man's how too. [img]/forum/images/graemlins/tongue.gif[/img] Remember I'm always open for suggestions. Will be working on the mold some more tonight.
strick
__________________
"I always wanted to piss in the Rhine" (General George Patton upon entering Germany) |
#4
|
|||
|
|||
![]()
Excellent work Strick.......That motor isn't a 1996 by any chance? I agree with the how-to comment.
__________________
Snookerd |
#5
|
|||
|
|||
![]()
Strick, I think if we took a vote and send the collection plate around, we could buy a web cam and have streaming video while you work.
![]() What-a ya think guys and girls, (we have to remember we have Darlene "Virgin Islander" with us now) Lets send Strick a web cam!!!!!! ![]() See ya, Ken
__________________
See ya, Ken © |
#6
|
|||
|
|||
![]()
Strick - I can set that up. We've got a few of them here for surveillance in Student Housing. One of them is focused right on the Pool in a freshman dorm . . . (for liability/safety reasons).
|
#7
|
|||
|
|||
![]()
How do we get THAT URL Big????
|
#8
|
|||
|
|||
![]() Quote:
Quote:
Mold with recesssed areas for future access hatches. It is waxed and ready for lay up. The radius's were made using modeling compounds from the local craft's store. It's not perfect but it dosent need to be. Strick
__________________
"I always wanted to piss in the Rhine" (General George Patton upon entering Germany) |
#9
|
|||
|
|||
![]()
I noticed in the shots where you had it on the boat that the stern edge mold board was against the transom.....so you did allow for that in the spacing to the front of the cap so you can slide it back the thickness of the glass???
|
#10
|
|||
|
|||
![]()
Good to see that motor getting used! Remember the paper fuel pump guts rot out on that motor. Easy, cheap change-out.
__________________
Snookerd |
![]() |
|
|