image test

[gofastsandman]

Hey GFS! What's up, Bud?

Before I forked out 10K for a mold or something similar for a press- through die, I'd check out some of this composite material they are selling for dimensional lumber for house exterior trim! Worse case scenario would be that you have to notch it a bit to get it to bend to the curve of the hull. I'm not sure what an appropriate adhesive would be, but kurf marks sound like a pretty good bonding surface on the substrate for some quicker curing epoxy! Just a thought. I wonder if you can get that stuff in true inch or inch and a half dimensional stock? I have been told that it takes paint and is sandable, too. Durability may be an issue depending on how soft it is.

Happy hour at Michael`s with the new Michael?
Hope to get up there next Sept for a little BFT fishin.
I`ve got some PVC rails I wanna plug a mold from. Still hunting for a suitable cost effective castable resin. Mark Nichols of DOA lures microwaves his vinyl for casting. The industry gurus say that`s not possible, but I know better, and so does he! I want to make lots of them. Lots and lots.
GFS