Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > General Discussion > Repairs/Mods.
FAQ Community Calendar Today's Posts Search

Notices

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 06-16-2010, 10:54 AM
mnwnvc mnwnvc is offline
Senior Member
 
Join Date: Mar 2008
Location: New York Upstate
Posts: 149
Default Re: Drilling motor mounting holes

I machined a piece of one inch aluminum bar stock with a step and the lower portion being a snug fit in one of the mounting holes of the engine. The center of the barstock was drilled out for an appropriate drill size. Tap the fixture into a mounting hole and drill. Worked great.
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 01:37 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft