![]() |
|
#1
|
|||
|
|||
![]()
ummmm....there is a bulkhead between the fish box and fuel tank. the fishbox (I don't use it for that) drains to bilge.
|
#2
|
|||
|
|||
![]()
sunshine marine just did a tank for my 23 contender. i got about 130 gallons.
|
#3
|
|||
|
|||
![]()
It's been HOT but I've been doing what I can. I hope to mount the bracket/engine this week. I installed Gem low profile deck drains, all hatches/hinges/latches/rod holders, etc. Most are drilled oversize, epoxied with West 610 and thru-bolted. I made the bow area access from 1/2" starboard and the gunwale supports from 1" starboard. I pilot drilled the transom from a template. The plan is to lag bolt the bracket and thru drill together from inside.
![]() ![]() ![]() ![]() ![]() ![]() ![]() |
#4
|
|||
|
|||
![]()
Will your deck drain out the transom? Nice work.
|
#5
|
|||
|
|||
![]() Quote:
|
#6
|
|||
|
|||
![]()
Please post photos of transom with drain outlets when done. I am about to redo the deck on my 1974 and likely will go with the same Hermco bracket. Thanks.
|
#7
|
|||
|
|||
![]()
With those taller stringers (raised floor) that should make your scuppers a breeze! I had some trouble with mine because my floor is at stock height.
How difficult was that 1/2in starboard bulkhead (for the anchor locker) to get under the gunwale?
__________________
Patrick from WAY out on cape cod. 1973 23foot Center console, Birdsall Ttop, Hermco Bracket... in progress |
![]() |
|
|