Yeah just polyester resin and 1708 is all I have used on my last two boats. Used epoxy for fillers and what not.
I believe its 20" on 20sf and 24" on MA. We were able to pull the cap up alittle and get some more freeboard. I had raised my floor a total of 5" from top of factory to top of new floor and was about to pull the cap up another 1" so I still have 20" at the stern. Your right about the liner for the back. Definatly will feel alot wider.
I kinda wish I would have splurged and maybe done a composite transom on my last MA cause 30-40lbs in the rear of these boats is actually alot.
|
11-01-2011, 08:54 PM
Threaded Mode