20 MA project continues

[fdheld34]

Damn Dixon..I wanted to spend his money....
-Fred

[eggsuckindog]

sorry

he can buy a Stilletto prop for the difference - just say'in

[hugo]

dont forget the miami marine flea market is on this weekend at tropical park, find some hydrolic steering, you wont regret it.

[jorgeinmiami]

Thanks for the tip I will for sure head out that way

Anyone else heading out?

[jorgeinmiami]

Originally Posted by fdheld34

Damn Dixon..I wanted to spend his money....
-Fred

My wife says that same thing

SHE wants to spend my money too!!!

[fdheld34]

Jorge...I know the feeling as well...!

-Fred

[jorgeinmiami]

Did the bases for the bilge pimps and thru hull today tomroow I'll glass them in
Install a battery and switch but did not do a permanant job, I just wanted to start the engine.
Put some gas in the tank and hit the switch and it started with no trouble at all.

What a relief that it started and ran good I need to fix the lower unit seal as is is leaking lower unit oil in the propeller area and change out the impeller.

I will more than likely do some minimal electrical done and finish as the summer progresses and see what I need

The trim....... I guess I need some type of relay or something to get it going.
On the bottom of my binicule the is a set of 3 wires that finishes in a plug that should go to something.
What is it that it plugs into and where do I get it

What do I need for this?

Next I need to do the trailer so I can get it in the water


I'm so close to getting in the water I can smell it

[jorgeinmiami]

Glassed in the bases for the 2 bilge pumps and the base for the thru hull

Installed both pumps and the thur hull and pump I need to get the electric to them but that will be sometime this week. I also need to get the 2 batteries connected to the battery switch

Installed the fuel gauge in the dash but not to the sender, next is the tach

Played with the trim and got that going but I think I have 1 selenoid that is bad and I need to get the trim fluid right. I bought some today and when I was adding it the fluid that was in there came up to the top did not look right, not that it had water, but it may be just old. I would like to flush it out and in with new fluids.

next I really need to get the trailer going as I will be needing to move the boat to the mechanic to get the lower unit looked at, I am leaking lower unit oil from the seal on the prop shaft and I want him to look it over before I go any where

And boy was it hot today!!


I guess pics will be asked for and they will up tomorrow