Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > General Discussion > Repairs/Mods.
FAQ Community Calendar Today's Posts Search

Notices

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 02-27-2013, 09:22 PM
CHANCE1234 CHANCE1234 is offline
Senior Member
 
Join Date: Mar 2003
Location: Cape Cod
Posts: 903
Default

I removed an old transducer tonight and will put the new ducer in the same spot after I drill a larger hole. The hull thickness in the location is about 1/4 inch. Is this thickness about right for the 20s? The hole is about 18 inches forward of the stern starboard side of keel by about 6 inches. The old ducer was so old the wire had either rotted off or been cut at some point. Any one recognize the make of transducer and its approx age. There was a transom mount ducer which was being used when I bought it.



Reply With Quote
  #2  
Old 03-13-2013, 05:32 PM
CHANCE1234 CHANCE1234 is offline
Senior Member
 
Join Date: Mar 2003
Location: Cape Cod
Posts: 903
Default

Got the engine hung. Which means the transom is done done. I still need to get the extension kit. Right now the cav. Plate is 4 inches above the keel, so I'll probably taise the engine up 2 maybe 3 holes.





Then instal tank, run wires and finally do the deck.
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 08:22 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft